Flowserve SLD Manuale Utente Scaricare il pdf

Sommario

InstallationInstructionsExperience In MotionSLDSynthetic Lubrication Device Seal Support System

2SLD Installation InstructionsThe following instructions are designed to simplify the installation of a typical SLD (Synthetic Lubrication Device) sea

Pagina 3 - Figure 1

3contaminating the seal quench chamber. The SLD Seal Support System is a single point lubricator and is not designed to supply more than one seal quen

Pagina 4

4 It is recommended that the shortest possible pipe length be used. The piping should be installed with good design and minimal bends from the SLD to

Pagina 5 - 2 Normal Operation

5Set Dispensing Rate Figure 230 - 3214 - 157 - 84 - 53 - 42.5 - 32 - 2.51 - 21 - 1.40.8 - 10.7 - 0.80.5 - 0.70.25 - 0.30.1 - 0.15475cc Jumb

Pagina 6 - 3 Dispensing Variations

62.3 If it is desired to decrease or increase the rate of lubricant dispensing after initial setting, simply click all the DIP switches to “Off” and

Pagina 7 - 4 Maintenance

7For example, at 37°C (98°F), the dispensing rate will be 12% faster. Similarly, at 9°C (48°F), the dispensing rate will be 8% slower. Installationat

Pagina 8 - 5 Specications

TO REORDER REFER TOB/M #F.O.FIS119eng REV 03/13 Printed in USAﬂowserve.comTo ﬁnd your local Flowserve representativeand ﬁnd out more about Flowserve C