Flowserve RIS Seal Manuale Utente Scaricare il pdf (Pagina 5)

10 adjusting stud is mounted to the bearing housing. If your pump is

thistype,mount101clampring,9jamnutsand10studstothebearing

housing at this time.

 3.4.2 IfOEMpumppartsaremodiedinlieuofanew46cover, 

  install139endplateleaving40boltslooseatthistime 

  (ifused),10adjustingstuds,101clampringand9jam 

  nutstothemodiedpartsasshownontheformdrawing.

 3.4.3 Installassembled46coverormodiedpumppartsonthe 

  pumpandtightentheattachingboltshandtight.Slidethe 

appropriate centering tool on the shaft and through the

  openinginthesealcoveruntilitslipsintothecoverbore. 

  Wrenchtightenthecoverattachingboltstolockthecover 

  inplace.Ifacenteringtoolisnotavailable,useadial 

  indicatorandcenterthecovermanuallywithin0.381mm 

  (0.015inch)totalindicatorreading.SeeFigure4.

4 Seal Assembly

Install Assembled Cover or Modied Pump Parts Figure4

Centering Ring

4.1 Assemblethestationaryfaceassemblytothesealcarrier.See

Figure5.

 4.1.1. Insertdrivepinsinthestationaryfaceassembly14.

 4.1.2. Alignthedrivepinholesinthestationaryfaceassembly 

  14 withthedrivepinsinthecarrier 240andassemble 

the parts until fully seated.

4.2 Install 71 O-ring (liberally coat with silicon grease) in the O-ring

grooveof 46 coverormodiedpumpparts.Handtightenendplate

139 bolts.

46Cover

1 2 3 4 5 6 7 8 9 10 11 12

Nessun commento

Flowserve RIS Seal Manuale Utente Pagina 5